Wash & Wax
Price:
Small Car - £100
Medium Car - £120
Large Car - £150
Time:
Small Car - 4 Hours
Medium Car - 4 Hours 30 Minutes
Large Car - 5 Hours 30 Minutes
pH Safe 7-Step Decontamination Wash Process
Pre Wet
Step 1: We pre wet the car and begin to remove any large bits of dirt, grime or contaminants from your car using the water from the pressure washer.
Snow Foam
Step 2: A thick layer of pH safe snow foam will be applied to the entire car. It begins to break down and remove any dirt, grime and contaminants to the surfaces of your car. The snow foam is washed off and exposes the areas that have got particularly stubborn bits of grime that will need more specific products to be applied to remove them.
Bug Removal
Step 3: We apply one of our specialist pH safe products to any areas off your car that have got bug splats, bird poo marks, tree sap, grease and grime on it. We end up covering most of your car during this step, only working in small sections at a time as we gently massage it around with one of our brushes. After we complete each section we give it a rinse with water and re check the surface, if there are still any bugs or bits of grime left on we will repeat the process once more.
Wheels & Brakes
Step 4: We then move onto your wheel arches, wheels and brake callipers, depending on the material and finish of these items we have a variety of different pH safe products that gently clean and remove any contaminants that you would find on them without damaging or staining them in the process.
Degreasing
Step 5: We then move onto degreasing all of your car, ensuring we don’t forget to get into those hidden, hard to reach areas that get a build up of grease and grime. We apply one of or a mix of the pH safe and other specialist products we use to degrease and remove tar, oils, dirt and grime from these areas.
Iron Fallout
Step 6: Depending on the condition and type of materials used on your car, we will use one of our pH safe iron fallout remover products. This product breaks down and safely removes the iron particulates that are bonded to the paint's surface.
3 Bucket Shampoo Wash
Step 7: Our 3 bucket safe wash is designed to protect your paintwork and other sensitive areas as good as we can during this process. We use an extremely high quality pH safe shampoo that provides superb cleaning power whilst also protecting your sensitive paintwork. It does this because it contains a lot of surfactants, detergents and lubricants, these help to encapsulate and safely remove any nasty bits of dirt or grime that may cause damage to your paintwork. We then give your car a thorough rinse down, afterwards we have a thorough check over to make sure we have got every part of it cleaned to our standards.
Drying Phase
We now move onto the drying process, where we use a combination of warm blown air and extremely plush drying towels to get rid of as much of the water as possible.
Pre Wax Wipe
We apply a product that is designed to remove any remaining bits of oil film, tar, tree sap and any previous waxes applied to the surfaces of your paintwork. This gets it ready to take on the high grade waxes used.
Wax On Wax Off
We then move onto applying one of our professional grade waxes to all the paintwork of your car. It is then allowed to cure and once ready we buff and polish it off by hand. The results are astonishing, it brings a completely new level of depth and clarity to your paintwork. This comes with the added benefit of hydrophobic protection and when properly looked after can last up-to 6 months.
Dressing The Trim
Often overlooked the black plastic trim and any other types of trim your car has eventually begins to lose the oils from within it and ends up degrading over time, the products we use helps to restore and rejuvenate the trim leaving it with a lasting finish that really makes your car stand out.
Tyre Dressings
We apply a high quality tyre dressing to all the tyres, which gives them that factory fresh look again.
The Finishing Touches
We open up the bonnet, doors and boot of your car and touch up and clean any areas with dirt or contaminants left over from the wash process
We will then clean all the glass surfaces both inside and out of your car
Your car is then given a thorough check over to make sure we have cleaned all the various parts to our standards. We will then use a variety of products if needed to add any remaining finishing touches to your pride and joy.
Pre Inspection Form sent to you via email which will contain:
- Tyre depth
- Any damage or wear and tear found on the vehicle
- Additional comments